Hi, I've modified the USBasp firmware from 2011-05-28 to add automatic speed detection, but I would like someone else to check over my work before I release it at large. I've done a bit of very basic testing to see if it works, mostly 'can it communicate' and 'can it read flash', but I don't have a large range of devices to check it on. How To Check Usbasp Firmware Version 8/24/2019 I have the USBasp programer and I'm trying to burn bootloader on Atmega328 so that it can be used as a replacement chip in Arduino board (replacement chips with the bootloader installed are quite expensive). If you short out this jumper, the USBasp goes into a special mode that changes it from being a programmer to being a target. This is to allow you to update the firmware on the USBasp itself using another programmer. Target power jumper. With this jumper in place the USBasp will supply power to the target via the ICSP header. This is usually. To disable this feature, specify the -D option. Avrdude: current erase-rewrite cycle count is -50462977 (if being tracked) avrdude: erasing chip avrdude: warning: cannot set sck period. Please check for usbasp firmware update.
Help! I've spent the last couple of hours banging my head against the wall. I was trying to update my firmware with my new usbasp programmer, and have only managed to erase my chip.
I bought the programmer off ebay (it says USBASP V2.0 - LC Technology), and wired an adapter cable with the following mappings (from Sanguino to programmer):
1 - 9 (MISO)
2 - 2 (VCC)
3 - 7 (SCK)
4 - 1 (MOSI)
5 - 5 (CS)
6 - 10 (GND) Stalker clear sky artifact.
When using, it, the 1284p is detected and has the correct signature, and I can successfully read and change the fuses, so the connection seems okay. However, when trying to upload a bootloader or marlin build, it always fails to verify as follows. Any ideas? The programmer itself only has a jumper for 3.3/5V (currently set to 5V).
>avrdude -C .etcavrdude.conf -c usbasp -p m1284p -U flash:w:SolidoodleMarlin.cpp.hex -v -D
avrdude: Version 5.4-arduino, compiled on Oct 11 2007 at 19:12:32
Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
System wide configuration file is '.etcavrdude.conf'
Using Port : lpt1
Using Programmer : usbasp
AVR Part : ATMEGA1284P
Chip Erase delay : 9000 us
PAGEL : PD7
BS2 : PA0
RESET disposition : dedicated
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Timeout : 200
StabDelay : 100
CmdexeDelay : 25
SyncLoops : 32
ByteDelay : 0
PollIndex : 3
PollValue : 0x53
Memory Detail :
Block Poll Page
Polled
Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW Max
W ReadBack
----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ---
-- ---------
eeprom 65 10 128 0 no 4096 8 0 9000 90
00 0xff 0xff
flash 65 10 256 0 yes 131072 256 512 4500 45
00 0xff 0xff
lock 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
lfuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
hfuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
efuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
signature 0 0 0 0 no 3 0 0 0
0 0x00 0x00
calibration 0 0 0 0 no 1 0 0 0
0 0x00 0x00
Programmer Type : usbasp
Description : USBasp, http://www.fischl.de/usbasp/
avrdude: AVR device initialized and ready to accept instructions
System wide configuration file is '.etcavrdude.conf'
Using Port : lpt1
Using Programmer : usbasp
AVR Part : ATMEGA1284P
Chip Erase delay : 9000 us
PAGEL : PD7
BS2 : PA0
RESET disposition : dedicated
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Timeout : 200
StabDelay : 100
CmdexeDelay : 25
SyncLoops : 32
ByteDelay : 0
PollIndex : 3
PollValue : 0x53
Memory Detail :
Block Poll Page
Polled
Memory Type Mode Delay Size Indx Paged Size Size #Pages MinW Max
W ReadBack
----------- ---- ----- ----- ---- ------ ------ ---- ------ ----- ---
-- ---------
eeprom 65 10 128 0 no 4096 8 0 9000 90
00 0xff 0xff
flash 65 10 256 0 yes 131072 256 512 4500 45
00 0xff 0xff
lock 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
lfuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
hfuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
efuse 0 0 0 0 no 1 0 0 9000 90
00 0x00 0x00
signature 0 0 0 0 no 3 0 0 0
0 0x00 0x00
calibration 0 0 0 0 no 1 0 0 0
0 0x00 0x00
Programmer Type : usbasp
Description : USBasp, http://www.fischl.de/usbasp/
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.02s
avrdude: Device signature = 0x1e9705
avrdude: safemode: lfuse reads as DE
avrdude: safemode: hfuse reads as DB
avrdude: safemode: efuse reads as F8
avrdude: reading input file 'SolidoodleMarlin.cpp.hex'
avrdude: input file SolidoodleMarlin.cpp.hex auto detected as Intel Hex
avrdude: writing flash (110734 bytes):
Writing | ################################################## | 100% 59.31s
avrdude: 110734 bytes of flash written
avrdude: verifying flash memory against SolidoodleMarlin.cpp.hex:
avrdude: load data flash data from input file SolidoodleMarlin.cpp.hex:
avrdude: input file SolidoodleMarlin.cpp.hex auto detected as Intel Hex
avrdude: input file SolidoodleMarlin.cpp.hex contains 110734 bytes
avrdude: reading on-chip flash data:
Greek to hebrew and hebrew to greek dictionary of septuagint words audio. Reading | ################################################## | 100% 57.39s
avrdude: verifying ..
avrdude: verification error, first mismatch at byte 0x0000
0x0c != 0x00
avrdude: verification error; content mismatch
avrdude: safemode: lfuse reads as DE
avrdude: safemode: hfuse reads as DB
avrdude: safemode: efuse reads as F8
avrdude: safemode: Fuses OK
Root CA / CA / Sub CA: Certificate: CRL: Test Certificate: CCA India 2015 SPL: NA: e-Mudhra CA SPL 2015: NA: e-Mudhra CA SPL 2015-1: e-Mudhra CA SPL 2015-2: NA: CCA India 2014. Etoken Pro 72k Java Software Freeware JSET - Java Software Evolution Tracker v.1.0.0 jSET - Java Software Evolution Tracker is a software visualization tool that allows practitioners to assess the magnitude of changes across the versions of a software system. Aladdin eToken Pro USB 72k USB security key overview and full product specs on CNET. Microsoft Windows 2003, Microsoft Windows Vista / 2000 / XP. Microsoft Windows Vista / 2000 / XP. Aladdin etoken driver. The eToken runtime environment (RTE) installs all the necessary files and eToken drivers to support eToken integration with various security applications. It enables Windows operating system and third party applications to access the eToken. This version supports Windows XP. DRIVER ALADDIN ETOKEN PRO 72K JAVA FOR WINDOWS XP. Pro manual installation, national certifying authority, globalsign java software evolution tracker. Java software evolution tracker. Token firma digital, accesorios para notebooks tokens. Debbie kaye aladdin. Pro java software evolution tracker. Data protection support.
Usbasp Avr Programmer Driver
avrdude done. Thank you.
